Does the amount of oxygen (O2) produced by water weed (number of bubbles) fluctuate (increase/decrease) with changing light intensities?

Independent variable &ndash; the light intensity (varying from a scale of 1 &ndash; 10, unknown units)

&nbsp;

Dependent variable - The number of bubbles produced over a known period of time (O2 production)

It is possible to show how oxygen evolves during photosynthesis using aquatic plants. Theoretically, an aquatic plant will undergo photosynthesis and release bubbles of oxygen-containing gas when it is submerged in a solution containing a source of carbon dioxide [CO2] and exposed to light of the proper intensity. These bubbles may be counted, and the bubbling rate can be used to estimate the speed of photosynthesis. The rate of bubble generation should rise when the light intensity is raised. Reduce the light&#39;s intensity, and the bubbling should slow down. The bubbling should stop if the light source is completely removed or if you relocate into an area where the energy levels are too low for photosynthesis.

photosynthesis.svg

The process of photosynthesis requires light. In the absence of light, green plant cells cannot photosynthesise. Up until a certain level of light intensity [typically 38% -(1)] above which the rate does not increase because the light saturation point has been reached and another factor (CO2 concentration or temperature) is limiting, photosynthesis will increase as light intensity increases.

&nbsp;

In this experiment, the amount of light is altered by lowering the amount of light. The quantity of oxygen bubbles should decrease as photosynthesis proceeds more slowly.

As photons are absorbed by pigments in photosystems, which is how plants receive light energy, I believe that if the light intensity is very low, the number of oxygen bubbles created will likewise be very low. This energy is what propels the photosynthetic process. Water won&#39;t undergo photolysis at low light levels, hence O2 won&#39;t be produced as a byproduct. More photolysis takes place to replace the high energy electron as the light intensity rises because more electrons are activated in the photosystem&#39;s reaction centre. This releases more oxygen, which is seen as more bubbles.

&nbsp;

The number of bubbles may plateau at the highest light levels because photosynthesis can be constrained by a number of variables, including light intensity, temperature, and carbon dioxide content. Even with high light intensities, the rate of photosynthesis is unlikely to keep growing since, for instance, carbon dioxide concentrations might not be at their ideal levels.

&nbsp;

Additionally, photosynthesis requires the presence of CO2, which the simulation delivers as a solution of CO2 with adjustable units 1&ndash;10.

&nbsp;

Although there is an excess of CO2, which is necessary for photosynthesis, the outcome will not be affected. In this simulation, decreasing CO2 levels might be investigated.

&nbsp;

During photosynthesis, chlorophyll absorbs light from the blue-green spectrum. These wavelengths are present in normal light, so using a standard light bulb (white light) without filters is adequate. Using this simulation, the use of coloured light could be investigated.

The experimenter can change the light&#39;s colour, carbon dioxide content, and intensity using this simulation.

&nbsp;

The virtual setup is depicted in the screen capture below.

water weed simulation.svg

The parameters were set on the simulation as follows:

<ul>
	<li>CO2 level =10</li>
	<li>Light filter white</li>
	<li>Speed x5</li>
</ul>

Data was collected from light levels 1 -10. 5 repeats were carried out at each light level.

raw data.svg

standard deviation.svg

confidence.svg

An increase in oxygen (bubble) generation from plant photosynthesis occurs when light levels rise. This outcome indicates that my theory was true.

&nbsp;

Unit 10 had light levels that were roughly twice as high as light level 5. This meant that photosynthesis levels at light level 10 were twice as high as those at light level 5. This also shows that there is a direct, positive association between light intensity and the quantity of bubbles created, with the number of bubbles at a light intensity of 4 units being double that seen with a light intensity of 2 units.

&nbsp;

In order to evaluate the experiment&#39;s dependability, standard deviation was determined. The results are more reliable when the standard deviation is lower since it depicts how the data vary from the mean. The graph illustrates that the standard deviation and 95% confidence intervals grow with light level, indicating that the data become less dependable as light intensity rises. The standard deviation was, however, minimal compared to the mean for all light intensities, being, at most, less than 8% of the mean value (for light level 2).

&nbsp;

The results of this experiment support the hypothesis that because there are few photons striking the photosystem and few electrons being excited to higher energy levels, photolysis does not occur frequently at low light levels. There is no photolysis, no water splitting, and little to no oxygen bubble emission on the part of the plant.

&nbsp;

As the light intensity rises, more photons are absorbed by the pigments and more electrons need to be replaced in the photosystem&#39;s primary reaction centre, which accelerates photolysis and produces more oxygen bubbles (2).

&nbsp;

My prediction that at a particular light intensity the number of bubbles will plateau because another factor would be limiting was only partially accurate. This did not occur, however it is possible that this was because the experiment was stopped before the light saturation point was reached.

Investigating The Effect Of Different Light Intensities On Water Weed

dr-angela-jebailey.png

Dr. Angela Jebailey

Experienced IB Bio teacher with a 6.18 student avg, ready to help you nail that 7!